Style selections SGY-GHR2 Manual Del Usuario página 5

ASSEMBLY INSTRUCTIONS
WARNING: If not properly installed, there is a risk of falling. Make sure your
installation can support the loads above.
CAUTION: When using power tools, please wear eye protection.
WARNING: Ensure there are no live electrical wires or plumbing in the wall at the
location you are drilling.
MOUNT TO STUD AND DRYWALL
Estimated Assembly Time: 20 minutes
Hardware Used
AA
Tools Required for assembly and installation (not included):
Stud-finder
Level
Drill & 3/8" (10 mm) Drill Bit, 7/32" (5.5 mm) Drill Bit
Hammer or Mallet
10 mm Wrench or Socket
1. Using stud-finder, locate stud and mark the
location.
2. Using mounting bracket (F) from the unit, hold
the bracket over the location you marked for
the stud. Make sure both holes on either the
left side or right side match up to the center of
the stud.
3. Using the level make sure the bracket is level
and then using a pencil or pen mark the four
(4) hole locations.
4. Using a 7/32" (5.5 mm) drill bit drill the 2 holes
you marked over the stud.
5. Using a 3/8" (10 mm) drill the other 2 holes
you marked.
6. Tap a plastic anchor into each hole you drilled
with the 3/8" (10 mm) drill bit with a hammer or
mallet.
7. Fasten the mount bracket (F) with four screws (AA) and washers (BB) to stud and
drywall.
8. Hang the hose reel (A) on the mount bracket (F), and secure it by inserting the
mount pin (E).
9. Connect with inlet hose (D) end with the water source.
x 4
BB x 4
Tape Measure
Pen or Pencil
Adjustable Wrench
5
CC x 2
2
7/32"
BB
AA
F
CC
3/8"