Style selections SGY-GHR2 Manual Del Usuario página 6

ASSEMBLY INSTRUCTIONS
MOUNTING TO A MASONRY WALL
Estimated Assembly Time: 20 minutes
Tools Required for assembly and installation (not included):
Level
Drill & 3/8" (10 mm) Masonry Drill Bit
Hammer or Mallet
9/16" (14 mm) Wrench
WARNING Ensure there are no live electric
wires or plumbing in the wall where you mount
the hose reel. Always use eye-protection when
using power tools.
1. Using mounting bracket (F) from the unit, hold
the bracket over the location you want to
mount the hose reel.
2. Using the level make sure the bracket is level
and then using a pencil or pen mark the four
(4) hole locations.
3. Make sure the nut is at the top of the thread on
the masonry anchor. Insert a masonry anchor
into each hole and gently tap the top of the
anchor until the anchor is fully seated in the
wall.
4. Remove the nut, lock washer, and flat washer
from the anchor. Mount the mounting
bracket (F) onto the masonry anchors, then assemble the flat washers, lock
washers and nuts. Tighten all nuts until the masonry anchors are secure.
5. Hang the hose reel (A) on the mount bracket (F), and secure it by inserting the
mount pin (E).
6. Connect with inlet hose (D) end with the water source.
Hardware Used
DD
Tape Measure
Pen or Pencil
Adjustable Wrench
x 4
6
3
DD
F