Tabla De Contenido; Precautions; Getting Started - Sony CPD-17F03T Manual De Instrucciones

Table of Contents
Precautions ............................................................................... 3
Getting Started ......................................................................... 3
Adjustments .............................................................................. 4
Power Saving Function ........................................................... 5
Plug and Play ........................................................................... 6

Precautions

Installation
• Prevent internal heat buildup by allowing adequate air
circulation. Do not place the unit on surfaces (rugs,
blankets, etc.) or near materials (curtains, draperies) that
may block the ventilation holes.
• Do not install the unit near heat sources such as radiators
or air ducts, or in a place subject to direct sunlight,
excessive dust, mechanical vibration or shock.
• Do not place the unit near equipment that generates
magnetism, such as a converter or high-voltage power
lines.
Maintenance
Clean the cabinet, glass panel, and controls with a soft cloth,
lightly moistened with a mild detergent solution. Do not use
any type of abrasive pad, scouring powder, or solvent, such
as alcohol or benzine.

Getting Started

Before using this monitor, make sure that the following
items are included in your package:
the monitor, power cord and this operating instruction
manual.
This monitor will sync to platforms running at horizontal
frequencies between 31.5 and 64 kHz.
Connecting the Computer
Step 1: With the monitor switched off, attach the power
cord to the monitor and then to the power outlet.
Power cord (supplied)
to the power
outlet
Damper Wire .......................................................................... 6
Use of the Tilt-Swivel ............................................................ 6
Specifications .......................................................................... 6
Troubleshooting ..................................................................... 7
Warning on Power Connection
• Use the supplied power cord.
for 100 to 120 V AC
For the customers in U.S.A.
If you do not do this, this monitor will not conform to
mandatory FCC standards.
• Before disconnecting the power cord, wait for at least
30 seconds after turning off the power switch to allow for the
discharging of static electricity on the CRT display surface.
• After the power has been turned on, the CRT is
demagnetized for approximately 5 seconds. This,
generates a strong magnetic field around the bezel, which
may affect the data stored on magnetic tape or disks near
the bezel. Place such magnetic recording equipment and
tapes/disks at a distance from this unit.
The socket-outlet shall be installed near the equipment
and shall be easily accessible.
Step 2: With the computer switched off, attach the video
signal cable to the video output.
Computer
to the video output
Step 3: Turn on the monitor and computer.
Step 4: If necessary, adjust the user controls according to
your personal preference.
The installation is complete.
for 220 to 240 V AC
EN
3