Publicidad
Idiomas disponibles
Idiomas disponibles
Note 2: In any case, check the position of the power outlet where the power cable will run, since
a hole might have to be made in the wall unit to accommodate it.
1. Take off the aluminum filter according to Pic.1.
2. Take off the lights according to the instruction showed in Pic.2. Take out the 2 screws on both
sides indicated in Pic.2.
3. Push upward to take off the front panel as indicated in Pic.3.
4. Drill 4 holes into the wall unit, following the distance indicated in Pic.4. Push the hood up
against the wall unit and attach the hood with 4 screws (ST3.9*25) as indicated in Pic.4.
5. Attach the front panel, lamps and aluminum filter in the reverse order as indicated in Pic. 5.
6. After you install the aluminum filter, attach the flexible pipe on the air outlet and seal with tape
and plastic strap as indicated in Pic.6.
7. Make the electrical connection.
The installation is now complete.
6
Publicidad
