Publicidad
Cylinder
• Remove the cylinder cover (A).
• Remove the cylinder piston (B) using a wrench.
• Clean the inside, the piston shaft (C) and the ring (D).
• Add grease into the inner wall of the cylinder and ring.
• Fill the orifice where the piston shaft is inserted (E).
Use pneumatic engine oil (SAE No. 10) up to the
washer first level. Set the piston back in place and close
the cover. Tighten firmly using the wrench.
Riveter Chucks
• To carry out maintenance in the riveter chucks you need to
remove them with the wrenches (F), then, disassemble the
head parts (G).
• Clean all the pieces and apply lubric.
• Assemble back the chuck. Using the wrench with adjusting
limits to assure the head length is adequate: 2
Otherwise, the riveter performance may be deficient..
8
ENGLISH
B
C
E
/
" (H).
13
16
Maintenance
Nozzle carrier
D
• At the bottom of the cylinder you can
screw the included extra nozzles to avoid
loosing them.
A
F
G
H
Publicidad
