Resulting fire or malfunctions
may lead to injury.
26. Always turn the appliance off
(O) before disconnecting the
GB
power plug.
27. Place the appliance on a wide,
level, dry and stable surface
able to support the combined
weight of the appliance and its
contents.
28. Do not pull the power plug out
of the electrical outlet by the
power cord.
29. Connect the mains plug to an
easily accessible socket, in
order to quickly disconnect
the appliance from the mains
supply in an emergency.
30. The appliance is not intended
to be used with a multi-
socket unit or an extension
cable. The power plug of
the appliance should have
its own independent and
properly grounded socket.
Using adapters may cause
overheating or fire.
31. The appliance must be
properly installed and located
in accordance with these
instructions before it is used.
32. Do not place the appliance
in direct sunlight or close to
any heat sources, as this will
hinder the cooling process.
33. The refrigerant and insulation
blowing gas used in the
appliance require special
disposal procedures. When
disposing of them, please
consult your service agent or a
similarly qualified person.
34. Do not place heavy objects or
objects filled with water, e.g.
vases, on the appliance.
35. Keep a minimum distance of
5cm between the appliance
and walls or other objects
on all sides and a minimum
distance of 20cm between the
appliance and the ceiling to
ensure proper air circulation.
If the distance is too small,
the cooling capacity may be
impacted.
36. After turning the appliance off,
always wait at least 5 minutes
until turning it on again.
Otherwise, the compressor
may be damaged.
37. The appliance is very heavy.
It is recommended to roll
or slide the appliance for
transport whenever possible.
If the appliance must be
lifted, please only do so
with specialized equipment
or have it lifted by qualified
professionals. This applies
to the packed as well as the
unpacked appliance.
38. Never tilt the appliance more
than 45° or turn the appliance
on its side or upside down to
avoid damaging the refrigerant
circuit.
- 13 -