Charger And Battery (D) - Rothenberger ROTIGER CL Instrucciones De Uso

Working Directions:
Sawing:
Use a saw blade geared to the material to be sawn.
Press the machine with the guide (2) against the workpiece. Switch on the machine, and only
then guide the saw blade against the workpiece.
Do not make contact with any objects or with the ground with the moving saw blade (danger of
recoil and saw blade fracture!).
Adapt the stroke rate to the material to the sawn.
Avoid excessive pressure on the saw blade (particularly in the case of long saw blades).
If the saw blade jams, turn the machine off immediately. Widen the sawn gap slightly with a suit-
able tool and take out the machine.
After completing the sawing cut, switch off the machine and only take it out of the sawn gap to
place it down once the saw blade has come to a standstill (danger of recoil).
Chain tube holder (C2):
 Place the chain tube holder on the tube.
The lever must be screwed in up to the stop!
 Place the chain on the tube and hook it in.
 Turn the chain tube holder firmly clockwise. Note: Thread must turn outward.
4.4 Charger and battery
Overview:
Battery pack
1
Sliding seat
2
Operation display
3
Start of operation
Before plugging in, check to see that the rated mains voltage and mains frequency,
as specified on the rating label, match your power supply!
Devices such as this one, which generate direct current, may have an effect on basic residual-
current circuit breakers. Use type F or better, with a release current of max. 30 mA.
Before commissioning the charger, ensure that the air slots are free. Minimum
distance to other objects is 5 cm/ 2"!
Self-test:
 Insert mains supply plug.
The warning display (4) and the operating indicator (3) light up one after the other for approx. 1
second and the installed fan runs for approx. 5 seconds.
Battery pack:
Charge the battery pack before use (1).
If performance diminishes, recharge the battery pack.
The ideal storage temperature is between 10°C / 50° F and 30°C / 86° F. The permissible stor-
age temperature is between 0°C and 50°C / 32° - 122° F.
Li-ion battery packs have a capacity and signal indicator: (6)
 Press the button (5), the LEDs indicate the charge level.
If one LED is flashing, the battery pack is almost flat and must be recharged.
Handling
Charging battery pack:
 Push the battery pack completely to the stop on the sliding seat (2).
Warning display
4
Capacity indicator button
5
Capacity and signal indicator
6
ENGLISH
(D)
21