AMS AMX 1224 USB Manual De Uso página 5

9. HI EQ
This control gives you up to 15dB boost or cut above 12kHz,and it's flat at
the detent.
10. MID EQ
This knob provides 15dB of boost or cut, centered at 2.5Khz,also flat at
the center detent.
11. LOW EQ
This control gives you up to 15dB boost or cut below 80Hz.The circuit is
flat at the center detent position.
12. AUX MON
These knobs tap a portion of each channel's signal to set up a nice monitor
mix feeding stage monitors, independent of the main mix.
13. AUX FX
These knobs tap a portion of each channel's signals to set up a nice FX
mix feeding the internal FX processor, and to feed external processors
via the FX output.
14. PAN
To balance the signals of the left/right of the corresponding channel.
15. MUTE / PEAK
Press this switch in to mute the channel in the main mix. Press the switch
up to use as PEAK, this LED indicates a signal level at the insert return
point, premaster fader, it illuminates at approximately 5dB below clipping.
16. CHANNEL FADER
These faders control the channel's level from off, on up to 10dB of additional
gain. The mono channels have mono faders, and the hybrid and stereo
channel use stereo faders.
AMX Series
9
10
11
12
13
14
15
16
- 3 -
EN
User Manual / Manual de uso