Battipav MIXIT Manual De Instrucciones página 15

Battipav srl
• remove the machine from its packaging
4
• screw the mixing whisk onto the head
5 • place the mixing head on the bucket by hooking the anti-rotation lock
• lock the three fastening hooks
AN AUTOMATIC SAFETY SWITCH DOES NOT ALLOW THE MACHINE TO START WHEN THE MOTOR HEAD IS
RAISED OR NOT HOOKED TO THE BUCKET,
CONNECTING TO POWER SUPPLY
THE MACHINE IS TO BE CONNECTED TO THE POWER SUPPLY BY A RESIDUAL CURRENT CIRCUIT BREAKER
(RCCB) WITH THE FOLLOWING CHARACTERISTICS:
RCCB In 16 A Id 30 mA
N.B. To ensure correct functioning, periodically check the efficiency of the RCCBs by pressing the push-button on the front
of the same.
• Make sure that the section of the power supply cable cores has been measured according to the starting current and its
length. For cables up to 50 m long, a section of 2.5 mm2 is enough.•
socket, check that the power supply voltage corresponds to that shown on the plate on the machine.
• The machine must be connected to an effective earth wire. In case of doubt, do not connect the machine.
CONTROL DEVICES
7
MIXIT is equipped with a control board made up of:
1) START BUTTON: (GREEN COLOUR)
Press the button fully to activate machine starting.
2) REGULAR STOP BUTTON: (RED COLOUR)
Press the button fully to activate machine stop.
3) NETWORK SEPARATOR (CONNECTOR):
Power supply point of the machine Once mixing is complete, during maintenance operations, unplug the device to disconnect it from the
mains.
4) AUTOMATIC SAFETY SWITCH
When the motor head is not attached to the bucket, the machine cannot start.
MIXING OPERATION
10
BEFORE STARTING THE MIXING OPERATIONS, THE OPERATOR MUST MAKE SURE THAT AT LEAST 150
CM ARE LEFT FREE AROUND THE MACHINE (POS. 2). IN ORDER TO WORK IN SAFETY CONDITIONS, DO NOT
LET OTHER PEOPLE REMAIN NEAR THE MACHINE DURING THE MIXING OPERATIONS. THE OPERATOR
STANDS IN THE WORKING POSITION (POS. 1) DURING THE DIFFERENT MACHINE OPERATION PHASES.
Glue for floor and wall tiles.
A) Carefully read the instructions on the sack of the glue for tiles you are going to use.
B) Pour in the basket the quantity of water necessary to prepare the desired glue quantity following the manufacturer's
instructions.
8
C) Start the MIXIT at speed 1, then tip the first 25 kg of powder at a speed of 10 kg/m. Continue with this operation in a
continuous and uniform manner with the second sack (25 kg) and wait for the whole product to be properly mixed. In this way,
the past will be free from lumps.
• If necessary, allow the glue to rest for 15 minutes and then mix it again for a few minutes.
• When mixing is complete, switch off the MIXIT and disconnect from the mains
As indicated in the previous paragraphs, the mixed product can be transported directly to the glue application location by
means of the wheeled trolley.
Cement
• The mixing machine is suitable for preparing mortar from plaster containing lime, cement and fine sized aggregates. It is not
suitable for mixing concrete or mortar containing medium-large sized gravel or aggregates.
• For the preparation of mortar for plaster, proceed as described in the foregoing paragraph: Glue for floor and wall tiles.
• As the mortar is a highly hygroscopic preparation, in order to prevent excessive hardening of the compound, a great deal of
Before connecting the machine to the power
GB
15