Publicidad
Idiomas disponibles
Idiomas disponibles
1. Start
All fans produced by SODECA, hereinafter the manufacturer, and the full line of accessories, have been manufactured in
accordance with the strictest standards in relation to quality assurance, systems and production processes.
Their project, testing, manufacture and control structure has been configured in line with EU standards and regulations,
especially in reference to current safety standards.
The materials used in our fans, and the standardised components of which they are made meet the same standards and,
when so required, are backed up by the corresponding quality certificates.
The Original Manual was written in Spanish.
The manufacturer reserves the right to make modifications without prior notice.
All the documentation in this manual is the property of the manufacturer, and its total or partial reproduction is prohibited.
2. Product Definition
CJTHT: 400ºC/2h and 300ºC/2h axial extraction units with soundproofed box.
CJTHT/ATEX: 400ºC/2h and 300ºC/2h axial extraction units with ATEX certification.
CJTHT/PLUS: 400ºC/2h and 300ºC/2h axial extraction units with built-in noise reducer.
IMPORTANT: This product is not suitable for use in explosive environments. (CJTHT, CJTHT/PLUS)
Maximum temperature of air to be carried: S1 continuous operation -20ºC +40ºC. Also suitable for hot climates with
temperatures up to 50ºC. S2 operation 300ºC/2h, 400ºC/2h.
3. General Information
•
Always check the products received.
•
After unpacking the equipment, it must be checked to make sure that it is not damaged. Damaged products must
never be installed.
•
This equipment must not be used for purposes other than those for which it was designed; it must only operate
under the conditions described in this manual.
•
In the event of a defect or malfunction, this must be reported to the authorised representative, with a description of
the problem, in order to coordinate its return or possible repair.
•
Before starting up the equipment, it is important to ensure that the safety and installation instructions in this
document have been read.
•
Before starting up the equipment make sure you have read the safety and installation instructions set out in this
document and the "General Specifications for ATEX Fans" attached to the product documentation.
(CJTHT/ATEX)
4. Transportation, storage and handling
•
Always hold the equipment at the points provided for this. Do not lift it by the electrical cables, connection boxes,
or the air inlet or outlet.
•
Before installation, store the equipment in a clean, dry place, protected from inclement weather.
5. Safety
•
Do not disassemble or modify the equipment. This could negatively affect the equipment or even cause accidents.
•
Do not put your fingers or any objects into the protective grilles on ducts, inlets or outlets. If this were to occur,
immediately disconnect the equipment's power supply.
•
Never use a damaged power cable.
•
Do not operate the equipment if it has been forcibly installed on a curved or unstable surface.
•
Do not perform equipment inspection or maintenance without first checking the following:
o
That the equipment has been disconnected from the electrical supply and the safety switch is locked.
o
That all its components are at rest.
•
The equipment must not be operated unless it has been properly installed and the inlet and outlet have been
protected, if necessary.
In designing and manufacturing the various Series of the manufacturer's Fans and Extractors, Hazard Elimination has been
taken into account, in order to meet the conditions for Integrated Safety.
When their configuration and manufacturing processes permit this, the manufacturer directly incorporates the most
appropriate Safety Devices. If the conditions for installation or use mean that these devices cannot be incorporated at source,
all additional safety accessories are available for implementation when the equipment is installed and before it is put into
service.
Publicidad
