Publicidad
Idiomas disponibles
Idiomas disponibles
English
Initial Setup
Essential Setup
1. Turn the turntable on its side and remove plastic pieces from the underside.
2. Insert the legs into the underside of the turntable and tighten.
3. Place the unit on a flat and level surface. The selected location should be
stable and free from vibration.
4. Remove the tie-wrap that is holding the tonearm.
5. Connect AC adaptor to the Power Jack of the unit.
Note: Do not plug the AC power adaptor to power outlet before all the assembly is
completed. Before turning the power on, make sure again all the connection settings
are correct. Always turn off the power when connecting or disconnecting.
Stereo System Connection
RCA Jacks
• The RCA Jacks output analog line-level signals and could be connected
directly with a pair of active/powered speakers or the appropriate input of your
stereo system.
• The Red plug connects with the Right channel and the White plug connects
with the Left channel.
Note: The RCA Jacks are not designed to be connected directly to the passive/unpowered
speakers. If connected to the passive speakers, the volume level will be very low.
Aux Input Connection
You can connect an audio device to this unit and play your music through its
speakers. To do this, rotate the Function Knob to / Aux In mode, connect the
3.5mm auxiliary cable between your audio device and the Aux In Jack of this
unit and start playing.
Note: The Bluetooth and Aux In modes are shared under the same Function Switch
position. When an auxiliary cable is plugged into the Aux In Jack, the Aux In function will
override the Bluetooth function.
Turntable Operation
1. Rotate the On/Off Volume Knob to turn on the power.
2. Rotate the Function Knob to PHONO position.
3. Set the Speed Switch accordingly.
4. Place the record on the turntable. Use the 45 RPM Adapter if necessary.
5
Publicidad
