Switch Lock; Operation; Routine Maintenance; Power Cord Maintenance - 909 NZN450 Manual De Instrucciones

Switch lock

The power switch can be locked
to prevent unauthorised use.
1. To lock the switch, switch off
the tool and disconnect it from
mains power.
2. Pull the switch lock key out.
GB
If the key is removed with the
switch in the "on" position, the
switch can be turned off but
cannot be turned on.
3. Refit the key by sliding it into
the slot on the switch until it snaps into position.

Operation

WARNING.
Do not sand metal with this sander. Sanding
metal will cause sparks that may ignite wood and dust
particles on the sander or in the workshop.
The spindle rotates in an anti-clockwise direction.
1. Make sure the nut (15) on top of the spindle is tightened
securely.
2. Turn the sander ON, and let the motor reach full speed.
3. Feed the workpiece gradually against the sanding sleeve.
• Do not force the workpiece.
• Guide the workpiece from the right to left. If you guide the
workpiece in the opposite direction, the rotation forces of
the spinning sanding sleeve will tend to throw or bounce
the workpiece away from the sanding sleeve.

Routine maintenance

WARNING.
Always ensure that the tool is switched off and
the plug is removed from the power point before making any
adjustments or maintenance procedures.
Regularly check that all the fixing screws are tight.
They may vibrate loose over time. Ball bearings are grease
packed at the factory, and require no further lubrication.
Use a spray lubricant on all moving table parts to ensure
smooth operation.

Power cord maintenance

If the supply cord needs replacing, the task must be carried
out by the manufacturer, the manufacturer's agent, or a
power tool repair center in order to avoid a safety hazard.

Cleaning

1. Remove dust and dirt regularly. Frequently blow
or vacuum dust away from all sander parts and the
motor housing.
2. Periodically remove the throat plate and lower washer
from the spindle and remove any dust accumulation in
the throat plate area.
3. Re-lubricate all moving parts at regular intervals.
4. Never use caustic agents to clean plastic parts.
Note. Do not use cleaning agents to clean the plastic
parts of the tool. A mild detergent on a damp cloth is
recommended. Water must never come into contact with
the saw.
10