Blowing Function; Care And Maintenance; Filter Cleaning; Warranty Conditions - Lavorwash ASHLEY 110 Manual De Instrucciones

potentially damp areas (for example in the
bathroom) .
18 Examine the mains cable and machine for
damage. If any damage is found, do not use
the appliance but contact your service centre
for repair.
20 Should extension cables be used, ensure that
these lay on dry surfaces and protected against
water jets.
21 The use of extension leads, connectors or
adaptors that do not conform to the applicable
regulations is not permitted.
23 The machine must be always used on horizontal
bases.
24 Do not use the machine without proper filters.
25 Do not use to vacuum water or other liquids.
26 These machine are not designed for picking
up health endangering dusts or inflammable/
explosives substances.
27 The cover of the motor compartment must only
be cleaned with a dry cloth.
29 Service and repairs must be carried out by
qualified personnel only. Only use manufacturer
original spare parts for service repair.
30 The manufacturer cannot be held responsible for
any damage/injury caused to persons, animals or
property caused by misuse of the appliance, not
in compliance with manual instructions.
Warning; risk of fire / flammable materials .
• do not pick up hot, glowing or burning ash. Pick
up cold ash only;
• the dust container must be emptied and cleaned
before and after each use;
• do not use paper dust bags or bags made from
similar flammable materials;
• do not use any other vacuum cleaner to vacuum
ash;
• do not rest the ash vacuum cleaner on flammable
or polymeric surfaces, including carpeting and
vinyl tile.
HOW TO PREPARE AND USE THE ELECTRIC
ASH VACUUM CLEANER
fig. ③④
• Make sure the filter is fitted in its housing .
- Insert cloth bag (13) fully inside cage (8) fig. ③,
Or:
- Remove the cage (8), push filter (12) fully home fig.
④.
• Connect steel pipe (9) to the relevant seat (7) fig.
④.
• B efore vacuuming the ash, check that it is cold
and no longer alight.
Do not vacuum burning embers
• D o not empty the drum into a container which
is easily inflammable and make sure that the
ashes are completely cool.
• If ashes hose becomes hot during use, turn the
device off immediately and let it cool.
• Turn the appliance on using the (I)ON/(0)OFF
switch, located on the cover of the motor.
• Vacuum the ash directly from the fireplace or from
the stove (wood or pellet-burning). Hold the suc-
tion nozze about 1 cm. above the ash.
• If there should be a reduction in the suction pow-
er, turn the motor off using the switch
• When the appliance is no longer in use, turn it off
and take the plug out.
• Perform the cleaning operations first on the
stove or fireplace and then on the appliance and
the suction filter (to be performed outside the
building).

BLOWING FUNCTION

fig.②
Before using the appliance blowing function,
proceed as follows to prevent dirtying the house
with ash:
• make sure the filter is clean.
• Make sure the drum is clean.
• Make sure the flex hose is clean.
• Make sure that filter is inserted in the relevant
seat.

CARE AND MAINTENANCE

The unit is maintenance-free.
• T he machine shall be disconnected from its
power source, by removing the plug from the
socket-outlet, during cleaning or maintenance
• Clean the exterior part of the machine with a dry
cloth.
• Move the appliance only by catching the carrying
handle located on the motor head.
• Store the appliance and the accessories in a dry
safe place, out of the reach of children.

FILTER CLEANING

fig.⑥⑦
• T he machine shall be disconnected from its
power source, by removing the plug from the
socket-outlet, during cleaning or maintenance
1- Remove the filter (12), (13)
2- Shake the filter (12), (13)
3- wash tge filter (12)
4- Let the filter (12) drying very well ,befor reas-
semble it
• O nce the filter has been cleaned, check whether it
is suitable for further use. If it has been damaged
or broken, replace it with an original filter.

WARRANTY CONDITIONS

All our machines are subjected to strict tests and
10