Descargar Imprimir esta página

Cleaning And Storage - Beem YD-3368 Manual Del Usuario

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

EN
4 – 8 cups
– 8 – 12 cups
Once the grinding process has fi nished, you will hear a beep and the grinder stops.
Notice: For technical reasons, a mechanical toothed wheel in the dial will continue to run for a
short while. This is not a defect.
5. Pull the collecting container forwards out of the motor unit.
The freshly ground coffee can now be processed further.
To obtain a successful result, you should keep a very close eye on the ratio of coffee powder
to water. If the water content predominates, the coffee loses its taste. If in turn you use too
much coffee powder, the coffee becomes too strong. We recommend that you start off with
15 g of coffee per 250 ml of water for a standard fi lter coffee. The dosing does of course
vary just like tastes vary from person to person and from speciality coffee to speciality
coffee, so you need to slowly get to know your own ideal ratio.

Cleaning and Storage

PLEASE NOTE
Do not use any toxic, corrosive or abrasive cleaning agents or scouring sponges to clean
the device. These may damage the surface.
Tap out the collecting container (6) and its lid, the grinding container (8) and the lid (7) and
clean everything with the cleaning brush that is supplied or wipe with a cloth. If they are very
dirty, detergent and warm water can be used.
All parts must be completely dry before they are reinserted and used or stored away.
Wipe down the motor unit (3) with a damp cloth. If necessary, use a little detergent to re-
move more intense soiling.
Check the connecting cable regularly for any damage.
Store the device and all accessories in a dry, clean, frost-free place that is protected from direct
sunlight and cannot be accessed by children or animals.
Cleaning the Grinder Shaft
1. Twist the grinding container (8) towards Grinding fi neness 15 so that the scale mark on the
grinding container extends a little beyond the mark on the motor unit (3) and pull the grinding
container up at the same time.
2. Clean the grinder shaft (1) on the inside with the cleaning brush that is supplied.
3. Place the grinding container on the motor unit so that the scale mark on the grinding con-
tainer and the mark on the motor unit overlap. Press down the grinding container and twist it
clockwise. It now fi ts correctly on the motor unit again.
18

Publicidad

loading

Este manual también es adecuado para:

03980