Replacing Seat
The rotating seat and the two ball bearing rings that move the seat can be
replaced if necessary. To remove seat and ball bearing rings, turn the lock
knob under the seat clockwise until removed. Remove seat and ball bearing
rings. Replace seat, ball bearing rings and lock knob. Tighten until secure.
Additional Precautions
1. Inspect all parts for shipping damage before assembly. If there is shipping
damage – DO NOT USE. Contact dealer/carrier for further instructions.
2. Make certain that the height adjusting snap buttons fully protrude through
the same respective hole of each leg extension. This will ensure that the leg
extensions are securely locked in position and an even height is achieved.
3. Check the rubber tips on the leg extensions for rips, wear or if they are
missing. Immediately replace any or all if any of these imperfections exist.
4. All four leg extensions with rubber tips MUST touch the floor
simultaneously at all times.
5. DO NOT stand on chair.
6. Only to be used on a flat and level surface.
NOTE: To maintain the beauty of the original finish, clean with mild soap and
rinse with warm water. Wipe bath seat dry after each use.
Lifetime Limited Warranty
Your Drive brand product is warranted to be free of defects in materials and
workmanship for the lifetime of the original consumer purchaser.
This device was built to exacting standards and carefully inspected prior to
shipment. This Lifetime Limited Warranty is an expression of our confidence in
the materials and workmanship of our products and our assurance to the
consumer of years of dependable service.
This warranty does not cover device failure due to owner misuse or
negligence, or normal wear and tear. The warranty does not extend to
non-durable components, such as rubber accessories, casters, and grips,
which are subject to normal wear and need periodic replacement.
If you have a question about your Drive device or this warranty, please
contact an authorised Drive dealer.
RTL12061EU (2021-03)
3/12