Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
other position may be dangerous
for the user.
Assembly the base (see picture 02 on page
4)
• Remote the product from the package.
• Fit the four base feet into the base
distributor and fix them with the
screws provided.
• Place the fan's body on top of the
extension tube, tighten the height
adjustment locking nut.
Assembly the blades and grills( see picture
03 on page 4)
• Remove the back grill and blade
fastener. Place the back grill against the
front of the motor housing through the
motor shaft. Ensure that the handle at
the back grill is facing up and that all
guiding pegs on the motor housing are
lined up with cutouts on the rear grill.
• Secure the back grill with the fastener
by tightening it in a clockwise direction.
• Install the fan blades onto the motor
shaft with the cutouts fitted.
• Place the fastener on the motor shaft
and blades.
• Fasten into place by tightening the
fastener counter-clockwise direction.
• Attach the front grill to the rear grill,
fastening it with the clamping ring
by using a screwdriver and tighten to
screw to secure it.
USING YOUR APPLIANCE
ABefore inserting the plug into
a power outlet, make sure that
the voltage corresponds to the
one indicated on the product
label, and that the plug has a
ground connection.
When using your device and getting the
most out of it, we recommend you take a
few minutes to familiarize yourself with
the correct way of using and using the fan
Control panel: (see picture 4 on page 4)
18
22.
On/Speed
23.
Timer
24.
Swing
25.
Off
Display: (see picture 06 on page 5)
26.
Timer light
27.
Normal mode light
28.
Natural mode light
29.
Night mode light
30.
Oscillation light
Remote control: (see picture 05 don page 4)
31. Timer
32.
On/Speed
33.
Off
34.
Swing
35.
Modes
• Place the fan on a flat, stable surface
and connect it to the power outlet.
• Press 'ON / SPEED' on fan's body or on
the remote control to turn on the fan.
• Press 'OFF' on fan's body or on the
remote control to turn off the fan.
• Adjusting the air flow speed by pressing
the "SPEED" button on the control panel
or the supplied remote control and the
fan will go through 3 speeds (Low /
Medium / High). The low speed has
been expressly designed for the hours
of sleep.
• Adjust the fan oscillation by pressing
the 'SWING' button to start or stop the
oscillation. Pressing the 'SWING' button
once, the fan will oscillate horizontally.
If you press again the oscillation will
stop.
• Timer setting by pressing the 'TIMER'
button on the control panel or the
supplied remote control. The timer can
be programmed in intervals of 0.5 hours
and up to a maximum of 7.5 hours. The
display will show the programming
time in each case. Once the time runs
out, the fan will turn off automatically.
• Mode setting, by pressing the 'MODE'
button on the supplied remote control
• NORMAL mode: the fan will work
normally.
Publicidad
