Druck UPS-III-IS Manual De Instrucciones página 10

Hart® Application
This application allows mA measure and source modes to be used through the Hart®
communicator.
Maintenance
• Return the loop calibrator to an authorised ATEX repair centre for any repairs, it cannot be
repaired on-site.
• To keep the loop calibrator accurate a calibration check should be carried out once per year.
Cleaning
• Clean the loop calibrator leather case with a moist, lint-free cloth and weak detergent.
Battery Replacement
WARNING: Only replace batteries in a safe area.
Only use the battery type listed on page two.
Unscrew and remove the securing screw from the battery panel. Replace the batteries, check the
polarity of the batteries. Refit and secure the battery panel.
K0341 Revision B
1
1 HART® communicator
2 Menu selectable loop
6
2