Electro Depot VALBERG 14S42 D DX AD 929C Instrucciones De Uso página 12

B
Using the appliance
Rinse aid
If the " " indicator lights up, this means that the
dishwasher's rinse aid level is low and its dispenser
needs to be filled.
Salt
10
Warning light
If the " " indicator lights up, this means that the
dishwasher is low on salt and a refill is required.
Water tap
If the " " indicator lights up, this means that the
water tap is closed.
Half load
When you only have about six place settings to wash,
you can choose this function to save energy and
water. (It cannot be used with the Auto, Fast and
Soak programs). When you press this button, the
Function indicator
corresponding indicator lights up.
11
lights
Additional drying
This function is used to dry tableware more. (It
cannot be used with the Auto, Fast and Soak
programs). When you press this button, the
corresponding indicator lights up.
Displays remaining time, waiting time, error codes,
12
Display
etc.
Water softener
• The water softener must be adjusted manually, using the water hardness indicator.
• The water softener removes minerals and salts from the water that would have a harmful
or undesirable effect on the operation of the appliance. The higher the mineral content of
your water, the harder it is.
• The softener should be adjusted according to the water hardness in your area. Your local
water authority can give you information on the hardness of the in your area.
Adjusting salt consumption
• This dishwasher can adjust the amount of salt used according to the hardness of the water.
This function allows you to optimise and adapt the level of salt consumption.
• Please follow the steps below to adjust the salt consumption:
1. After having closed the door of the appliance, switch it on.
20 EN
B
Using the appliance
2. Within 60 seconds of turning on the appliance, press the "Programs" button for 5 seconds
to enter the water softener setting mode.
3. Press the "Programs" button to select the correct setting for your local area. The settings
display order is as follows:
H1 -> H2 -> H3 -> H4 -> H5 -> H6.
4. Press the power button to exit the setting function.
WATER HARDNESS
French English
German
degrees degrees
degrees °dH
°fH °Clark
0 - 5 0 - 9 0 - 6
6 - 11 10 - 20 7 - 14
12 - 17 21 - 30 15 - 21
18 - 22 31 - 40 22 - 28
23 - 34 41 - 60 29 - 42
35 - 55 61 - 98 43 - 69
1 °dH = 1.25 °Clark = 1.78 °fH = 0.178 mmol/l
Default setting: H3
Contact your local water company for information on the hardness of your water.
NOTE : Please refer to the chapter "Adding salt to the water
softener", if your dishwasher runs out of salt.
21
Water Salt
softener consumption
Mmol/l
setting (grams/cycle)
0 - 0.94 H1 0
1.0 - 2.0 H2 9
2.1 - 3.0 H3 12
3.1 - 4.0 H4 20
4.1 - 6.0 H5 30
6.1 - 9.8 H6 60
EN