Prepare The Installation - Brandt BHC6601X Manual De Instrucciones

Information

Sufficient air is needed for proper combustion and exhaustion of gases through
the flue (chimney) of fuel burning equipment to prevent back drafting. Ductless
fans must always be vented to the outdoors.

When assessing the air pressure, the entire ventilation system in the
house/apartment must be taken into account, e.g. hob and/or gas cooker, this
rule does not apply.

Government regulations must be observed for the conveyance of exhaust air.
If the extractor hood is used in circulating air mode with activated carbon filter,
there are no
operating restrictions.
If you choose extraction-air mode,

install check valve on the vent hole .

Prepare the installation:

Ensure the power has been turned off before
beginning this installation. Plug must be
assembled in places easy to drag and insert.
To install this hood you will require two
assistants. You will need following tools
and material to complete this installation.
Tools you will need:

Drill appropriate to your wall

Phillips Screwdriver

Tape Measure

Hand Saw or Jig Saw
Installation work and electrical wiring must be done
by qualified person(s) in accordance with all applicable
codes and standards, including fire rated construction.
Do not discharge the exhaust air into a flue from other
appliances burning gas or other fuels. Regulations
concerning the discharge of air have to be fulfilled.
The cooker hood must be placed at a minimum distance
of 65cm above the cooking surface of a hob.
20
A
597/897mm
Min. 650mm
Max. 750mm