Installation And Removal Of Accessories - Create Steam Cleaner PRO 9 Manual Del Usuario

• After using the appliance, you should set the temperature to OFF, then pull out the plug;
otherwise, it will cause electrical leakage and injury.
• Regularly clean the dust and dirt, or it will cause fire accidents.
• Washing it with water to wet the body may cause electric leakage, damage, etc.
• Do not let the product fall or hit, as it will lead to electric leakage, short circuit, bodily
harm, gas and water leakage.
• Do not shake the product vigorously or invert the machine to use steam, which will lead to
the possibility of water leakage and burns.
• Please do not press the steam button continuously, as it will cause hot water leakage and
burn your body.
• When the body still has the residual heat, please do not remove the outlet head or remove
the brush accessories, which will burn and injure you.
• When the body still has the residual heat, please do not wrap the power cord on the prod-
uct, which will cause product fire and short circuit.
• Do not use polishing powder or corrosive cleaning liquid to polish the metal panel of the
product, as it will damage the product.
• Do not use thinner, naphtha, spray cleaners, alkali, etc., as they will cause the body to
deform and break down.
• During use, please make sure the types of clothes and cleaning standard are correct,
otherwise it may damage the clothes.
• While using the steam brush, please place it properly and make sure it is stable; other-
wise it may cause a fire.
• When adding and pouring water, you must unplug the power cord, or it will cause electri-
cal leakage.
• When the product is no longer in use, you must pour out the water and clean it, or the
water will give off a bad smell and even damage the product.
• Before cleaning and storing the product, make sure it is cool or it cannot cause burns.

INSTALLATION AND REMOVAL OF ACCESSORIES

• Confirm that there is no steam from the steam outlet hole before installing parts.
• Please confirm that the power cord is not plugged in before installation.
• Do not install or remove parts while connected to light.
ATTENTION:
• During use, please make sure that each part is fixed on the main body. During use, do not
replace parts to avoid burns.
• When you need to change any accessories, please turn off and unplug the power cord, cool
it down for five minutes, and then change the accessory.
E NGLI SH
9