INSTALLATION INSTRUCTIONS
We appreciate your commitment to KALLISTA quality products. Please take a moment to review this manual
before you install your KALLISTA product. If you encounter any installation or performance problems, please do
not hesitate to contact us at the phone number listed at the bottom of the page.
Observe all local plumbing and building codes.
The appearance of the sidespray may differ from the illustrations. The installation instructions still apply.
Install this product according to the installation guide.
Note: Plumbing codes require an atmospheric vacuum breaker be installed in-line with sidesprays. Ensure
that the faucet contains an atmospheric vacuum breaker, or consult with local plumbing officials.
Kallista reserves the right to make revisions in the design of faucets without notice, as specified in the Price
Book.
Ensure that the gasket is installed in the underside of the
spray holder.
Insert the spray holder into the mounting hole.
From underneath the mounting surface, install the spacer
(if needed) and nut. Securely hand tighten the nut.
Insert the sidespray hose through the spray holder until the
sidespray rests on the holder.
Verify that the sidespray outlet hose and the sidespray inlet
hose are both clean and free of debris. Verify that there is
an O-Ring in place on the sidespray inlet hose.
Remove the plug from the sidespray outlet hose coming
from the faucet. Connect the sidespray outlet hose to the
sidespray inlet hose.
Extend and retract the spray hose to check for smooth
operation.
Reposition the supply hoses if necessary.
1506282-2-A
2 of 5
THANK YOU FOR CHOOSING KALLISTA
BEFORE YOU BEGIN
INSTALLATION
Kitchen Sink Sidespray
Sink
Sidespray Outlet
(from faucet)
Remove plug
(if present)
Questions? Problems? For additional assistance, please contact KALLISTA's Customer
Service Department at 1-888-4-KALLISTA (1-888-452-5547) or kallista.com.
Sidespray
Spray Holder
Gasket
Spacer (for thin
mounting surfaces)
Nut
Sidespray Inlet
Hose