Error Indication - san ignacio 43817 Manual De Instrucciones

TEMPERATURE DISPLAY FUNCTION
When the scale is at off status, the LCD will show the
time and temperature.
After turning on the scale, the scale also will show
the indoor temperature.
TIME DISPLAY FUNCTION
If you need to adjust the time setting, keep pressing
the time setting button ("T-set"), you can select the
12-hour time mode or the 24-hour time mode using
the "on/off" and "unit" buttons.
After this, the hour will flashing, you can
adjust the correct time using "on/off" and "unit" buttons. Press the time setting button
to confirm the hour, then the seconds will be flashing. Adjust the seconds and press again
the "time setting" button to confirm.
The time setting is finished.
COUNTDOWN SETTING
1. When the display is on, press the "unit" button
during a few seconds to enter to the countdown
mode.
2. Once the time display is flashing, press the time
setting button and then use the on/off and unit
button to set the minutes and the seconds. Press the "time setting" button to confirm
and to start the countdown.
Note: you will only have 30 seconds to set the time; after 30 seconds, the scale will reset
the time.
3. After the countdown reaches 00:00, the scale will send an alarm for you. You can press
any button to stop the alarm.

ERROR INDICATION

The "Lo" symbol on the display indicates that the battery power is
running low. Please replace the batteries.