Charging The Device - UFESA SKIPPER MB6000 Manual De Instrucciones

In order to prevent any risk of danger, do not open the device. Only qualified technical
personnel from the brand´s O cial Technical support service may carry out repairs or
procedures on the device.
Any incorrect use or improper handling of the product shall render the warranty null and
void. Only an authorised technical support service centre may carry out repairs on this
product.
B&B TRENDS SL. disclaims all liability for damages that may occur to people, animals or
objects, for the non-observance of these warnings.

CHARGING THE DEVICE

Before using your beard trimmer for the first time, charge for 2-3 hours, and charge 2
hours regularly. Ensure the product is switched o . First insert the plug on the end of the
USB charging cable lead into the unit (Fig. 1) and then connect the USB charging cable to
the USB interface. This appliance is suitable for 5V DC Max 1A charger, computer and
other power interface (Fig. 2), the charging indicator is red when the battery is charging
connecting the USB interface, the charging indicator is green when the battery is full.
Your hair clipper cannot be overcharged. However, if the product is not going to be used for
an extended period time (2-3 months), unplug it from the mains and store. Fully recharge
your hair clipper when you like to use it again.
To preserve the life of your batteries, let them run out every 2 months then recharge for
2-3 hours again.
INSTRUCTIONS FOR USE
Prior to turning the device on, select the desired comb guide (a,b,c or d) fitting it by pushing
forward in a proper way (fig 3-4). If the hand combing needs to be replaced, pull upwards
by hand. Open the bottom end of the comb lock and push forward (fig 5-6).
Choose between four levels of matching comb to cut hair of di erent lengths. The length
of the cut is indicated on each limit comb as follows:
Number Level
1
2
3
4
length (mm)
1
2
3
4
3
6
9
12