Lcd Segments; Power Up Options; User Interface Description; Measurements - Wiha 45219 Manual De Instrucciones

LCD segments

Battery gauge
Alternating current, direct current
Measurement units
Messwert
Zeroing in DC clamp mode
Diode test
Continuity test
LP filter (AC) enabled
Automatic power off enabled
Non-contact voltage active
HOLD is enabled. Display freezes
current reading
Maximum, minimum, average
reading
Error messages on LCD
The input out of range

Power up options

Automatic power off function (APO) is turned on by default. APO will turn off the clamp
meter if passes 15 min. without activity.
Holding HOLD button while rotating switch from OFF to other position switches off
Automatic Power Off feature.

User interface description

With the rotary switch user can select the measurement mode. If the clamp meter
is in current [A] or voltage [V] mode it will be by default selected AC. Selection DC is
manually using Zero/Select button.

Measurements

When connecting the test leads to the circuit or device, connect the common
(COM) test lead before connecting the live lead; when removing the test leads,
remove the live lead before removing the common test lead.

Voltage measurement

To avoid electrical shock, the valid safety measures and VDE directives strictly
have to be met concerning excessive contact voltage when working with volt-
ages exceeding 120 V (60 V) DC or 50 V (25 V) rms AC. The values in brackets
are valid for limited areas (such as e.g. medicine, agriculture).
EN
23