Publicidad
Idiomas disponibles
Idiomas disponibles
Continuity test
Prior to any continuity test, it must be ensured, that the element to be tested is
not live. Failure to comply with this prescription can lead to dangerous corporal
user injuries or cause instrument damage. Additionally, external voltages falsify
the measurement result.
The shown value is indicative. The accuracy of continuity mode is lower than in
resistance measurement mode. Because of that the resistance measurement
shall be used for accurate results.
•
Set rotary switch to Ω/Diode/Capacitance/Continuity position.
•
After the clamp meter powers on use short presses of the Zero/Select button
to change measurement mode to Continuity.
•
Connect the black test lead to the COM socket and red test lead to the
V/Ω/Capacitance/µA socket.
•
Connect test leads to UUT.
•
The measured value displayed on the LCD.
Diode test
Prior to any diode test, it must be ensured, that the element to be tested is not
live. Failure to comply with this prescription can lead to dangerous corporal user
injuries or cause instrument damage. Additionally, external voltages falsify the
measurement result.
Resistors and semiconductor paths in parallel to the diode cause falsified meas-
urement results.
•
Set rotary switch to Ω/Diode/Capacitance/Continuity position.
•
After the clamp meter powers on use short presses of the Zero/Select button
to change measurement mode to diode test.
•
Connect the black test lead to the COM socket and red test lead to the
V/Ω/Capacitance/µA socket.
•
Connect test leads to UUT.
•
The measured value displayed on the LCD.
Capacitance measurement
Prior to any capacity test, it must be ensured, that the capacity to be tested is
not live. Failure to comply with this prescription can lead to dangerous corporal
user injuries or cause instrument damage. Additionally, external voltages falsify
the measurement result.
Resistors and semiconductor paths in parallel to the capacity cause falsified
measurement results.
Ensure that capacitors are discharged prior to testing!
•
Set rotary switch to Ω/Diode/Capacitance/Continuity position.
After the clamp meter powers on Use short presses of the Zero/Select button
•
to change measurement mode to Capacitance.
•
Connect the black test lead to the COM socket and red test lead to the
V/Ω/Capacitance/µA socket.
•
Connect test leads to UUT.
•
The measured value displayed on the LCD.
Frequency measurement
•
Set rotary switch to Frequency position.
•
After the clamp meter powers on connect the black test lead to the COM socket
and red test lead to the V/Ω/Capacitance/µA socket.
•
Connect test leads to UUT.
•
Read the measurement result displayed on the display.
EN
25
Publicidad
