Venga VG ACM 3000 Manual De Instrucciones página 10

Sleep mode
Press SLEEP button to turn the SLEEP function on.
•
After 1 hour the preset temperature is increased by 1°C, after another hour the
•
preset temperature will again be increased by 1°C.
Note : The sleep mode can be activated only in cool mode.
Timer setting
Press TIMER button to turn the TIMER function on.
•
Press ADD/MINUS buttons repeatedly to select the delay : from 1hour to 24hours.
•
To cancel, press the POWER ON/OFF switch.
•
Note : You can use the TIMER function to schedule the air cooler to stop or start.
PROTECTION FUNCTIONS
Automatic Defrost
If the sensor detects that the compressor temperature is too low or too different from
that of the room, the self-protection system activates automatically and shut-down to
defrost function and the POWER LED blinking.
Do not try to accelerate this defrosting process by any means.
•
10 to 20 minutes later, the compressor re-starts itself automatically.
•
Overheat Protection
In case of power loss, there is a 3-minutes delay to protect the compressor until it restarts.
DRAINAGE
Self-evaporating system
The condensing water will be recycled to cool the condenser. This can not only improve
cooling efficiency, but also save energy.
However, the internal water tank must be emptied regularly : when the water level
indicator lights up, this operation is necessary.
Switch OFF the unit before operating.
•
Remove the plug of the water outlet opening.
•
Connect the drain pipe and make sure it is not kinked and clear of obstruction.
•
Tilt the drain pipe downward (more than 20 degrees) over a bucket.
•
Water should freely flow out of the unit.
•
Do not submerge the end of pipe into water ; otherwise it "Air Locks" the pipe.
10 ACM 3000