Venga VG RVC 3001 Manual De Instrucciones página 6

REMOTE CONTROL
Automatic cleaning
Cleaning direction
control
Time setup
Spot cleaning
Room cleaning
Install 2 AAA batteries before using the remote control for the first time. Make sure the
positive and negative ends are facing the correct polarity direction as marked in the
battery compartment. (see "+" and "-" markings)
LED light
Breathing orange
Solid green
Solid orange
Off
Flashing / Solid red + Beeping
QUICK START
Plug in the charging dock, and place
the remaining excess cable into the
cable storage space at the bottom of
charging dock.
Note: if you don't put the excess cable
into the trunking, it may get tangled
with the robot while charging or
cleaning.
A. Charging dock position
1. Place the charging dock on a
hard, level surface and against a
wall.
VG RVC 3001
Status
Charging
Standby / Cleaning / Fully charged
Low power and returning to charging
dock
Robot is off
An error has occured. Refer to the
Troubleshooting - Error Tone section in this
instruction manual for solutions
6
Display screen
Return to charging
dock
Start/Stop
Schedule setup
Edge Cleaning
Max suction