General Power Tool Safety Warnings; Work Area Safety; Electrical Safety - Parkside PAMS 12 A1 Traducción Del Manual De Instrucciones Original

Total vibration value
(vector total of three directions) determined in
accordance with EN 62841:
Sanding
Vibration emission value
Uncertainty
NOTE
► The vibration emission values and the noise
emission values given in these instructions
have been measured in accordance with a
standardised test procedure and can be used
for comparison of the power tool with
another tool.
► The specified total vibration values and the
noise emission values can also be used to
make a provisional load estimate.
WARNING!
► Depending on the manner in which the
power tool is being used and, in particular,
the kind of workpiece being worked, the
vibration and noise emission values can
deviate from the values given in these instruc-
tions during actual use of the power tool.
► It is necessary to establish safety measures to
protect the operator based on an estimation
of the vibration load during actual use
(wherein all states of operation must be
included, e.g. times when the power tool is
switched off and times where the power tool is
switched on but running without load).
PAMS 12 A1
a = 3.107 m/s 2
h
K = 1.5 m/s 2
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-op-
erated (cordless) power tool.

1. Work area safety

a) Keep work area clean and well lit. Cluttered
b) Do not operate power tools in explosive
c) Keep children and bystanders away while

2. Electrical safety

a) Power tool plugs must match the outlet. Never
b) Avoid body contact with earthed or grounded
c) Do not expose power tools to rain or wet
General power tool
safety warnings
WARNING!
► Read all safety warnings, instructions,
illustrations and specifications provided
with this power tool.Failure to follow all
instructions listed below may result in electric
shock, fire and/or serious injury.
or dark areas invite accidents.
atmospheres, such as in the presence of flam-
mable liquids, gases or dust. Power tools cre-
ate sparks which may ignite the dust or fumes.
operating a power tool. Distractions can cause
you to lose control.
modify the plug in any way. Do not use any
adapter plugs with earthed (grounded)
power tools. Unmodified plugs and matching
outlets will reduce risk of electric shock.
surfaces, such as pipes, radiators, ranges and
refrigerators. There is an increased risk of
electric shock if your body is earthed or
grounded.
conditions. Water entering a power tool will
increase the risk of electric shock.
GB │ IE │ 3 ■