Cleaning And Maintenance - essentiel b EBL5s Instrucciones De Uso

before initial use
Remove all packaging.
1.
Before using the kettle for the first time, fill it up to the maximum level with cold water and
2.
boil once or twice to thoroughly rinse it.
Pour away the hot water collected.
3.
use
Place the kettle on a flat, stable surface.
1.
Completely unwind the power cord and insert the plug into a wall socket.
2.
Open the lid (5).
3.
Fill the kettle to the desired level, checking the water level indicator (3).
4.
!
Never fill the kettle to less than the "0.5 L" mark or over the "1.7 L" mark!
Close the lid and check that it is locked.
5.
Set the on/off switch to the I (on) position. The switch's indicator light turns on.
6.
When the water comes to the boil, the on/off switch automatically moves to "off" ("0") and
7.
the indicator light goes out.
To stop the kettle boiling before the auto-off engages, lift the switch to "off" ("0").
.
After the kettle has the boiled, pour the hot water carefully to prevent splashing.
8.
Wait at least 20 seconds before reheating.
9.
Always unplug the appliance from the mains after use.
10.
!
Burn risk! The kettle gets very hot during use and steam escapes from the pouring
lip. Make sure the lid is shut properly and do not touch the hot surfaces.
!
Make sure nothing is in the way of the switch and that the lid is closed securely.
Otherwise, the kettle will not be able to shut off automatically.
18

cleaning and maintenance

Cleaning
Always unplug the power cord and allow the kettle to cool down before cleaning it.
•
Never immerse the kettle, power cord or plug in water or any other liquid.
•
Clean the outside of the kettle with a soft, slightly damp sponge.
•
Never use abrasive detergents or scouring pads to scrub the inner or outer coating of your
•
kettle.
Descaling
How often descaling is required depends on how hard the water is and how often the
•
appliance is used.
Regularly descale your kettle to maintain it in good working condition.
•
In normal use, we recommend descaling your kettle at least three or four times a year.
•
To descale your kettle:
Pour in equal parts water and white vinegar up to the "MAX" mark.
1.
Bring to the boil and allow to work for 15 minutes.
2.
Carry out 3 boiling cycles with fresh water each time to thoroughly rinse the kettle.
3.
Special kettle descaler can also be used. In this case, follow the instructions on the packaging
and rinse thoroughly 2 or 3 times before using the kettle again.
Never use descaling methods that are not set out above. Malfunctions or faults due to a lack
of descaling are not covered by the kettle's warranty.
19