Descargar Imprimir esta página

Troubleshooting - Power Stroke PSi2100RT Manual Del Operador

Publicidad

Idiomas disponibles

Idiomas disponibles

PROBLEM
Engine will not start.
Engine hard to start
Engine lacks power.
AC receptacle does not work.
DC receptacle does not work.
Generator makes a "spark knock" or
"pinging" noise.
If problem persists after trying the above solutions, contact customer service or a qualified service center for assistance.
NOTICE:
As the equipment owner, you are responsible for the performance of the required maintenance listed in the Maintenance
section. It is recommended that you retain all receipts covering maintenance on your equipment. Neglecting or failing
to perform the required maintenance may increase emissions, decrease fuel efficiency, degrade performance, cause
irreversible engine damage and/or void your warranty.

TROUBLESHOOTING

POSSIBLE CAUSE
On/off switch is OFF ( O ).
No fuel.
Stale gasoline or water in gasoline.
Lubricant level is low.
Spark plug faulty, fouled, or improperly
gapped.
Choke knob is in run position.
Engine stored without treating or
draining gasoline, or refueled with bad
gasoline.
Dirty fuel filter.
Water in gasoline.
Weak spark at spark plug.
Dirty air filter.
Engine stored without treating or
draining gasoline, or refueled with bad
gasoline.
Generator is overloaded.
Item plugged in is defective.
Circuit protector engaged
Item plugged in is defective.
An occasional light "knocking" or "ping-
ing" under heavy load is not a cause
for concern. However, if the knocking
or pinging occurs under normal load
at a steady engine speed, the problem
may be with the brand of gasoline be-
ing used.
18 — English
SOLUTION
Turn on/off switch to ON (I).
Fill fuel tank.
Drain entire system and refill with fresh
fuel.
Engine is equipped with Low Oil Shutoff.
If engine lubricant level is low, it must be
filled before unit will start. Check engine
lubricant level and fill, if necessary.
Replace spark plug.
Pull the choke knob out to the start
position.
Drain fuel and carburetor. Refuel with
fresh gasoline.
Contact a qualified service center.
Drain entire system and refill with fresh
fuel.
Contact a qualified service center.
Check air filter element. Clean or
replace as needed.
Drain fuel and carburetor. Refuel with
fresh gasoline.
Remove loads and press the reset
button.
Try a different item.
Remove any load from the generator.
Turn the auto idle switch to off, then
depress the DC circuit breaker.
Try a different item.
Switch to a different brand of gasoline,
making sure that the octane rating is 86
or higher. If problem continues, contact
a qualified service center.

Publicidad

loading