Suitable Amplifier - auna SELECT Reference Manual De Instrucciones

EN
28

SUITABLE AMPLIFIER

The speakers of the Reference series are typical 4 ohm speakers that
harmonise with any HiFi amplifier without damaging it. We recommend
an amplifier with an output power according to the table below; in case of
doubt, the value may also be slightly exceeded. Please note: When listening
at high volumes, it is more likely to damage a speaker with an amplifier that
is too low in power than with a device that "has too much power". Reference
speakers can actually play music louder than many other HiFi speakers. If
you still hear distortion, reduce the volume slightly.
Model
801 standing speaker
802 shelf speaker
803 centre speaker
Connection Reference 801
We recommend that you use speaker cable with a diameter of at least
2.5mm² for the Reference 801 floor-standing speaker. The shorter the cable,
the better the sound. Cables up to about 5 m in length are absolutely safe
to use. For a conventional connection without bi-wiring, please connect the
upper and lower connection pairs with the supplied bridges as shown in the
illustration.
Then connect one end of your speaker cable to the two lower terminals
of your speaker. Now, when connecting the other end to the amplifier, be
sure to connect the PLUS terminal (usually RED) of the amplifier to the
PLUS terminal of the connection panel - and MINUS (usually BLACK) to the
MINUS.
Amplifier output power
100-300 W
100-150 W
100-200 W