Shark HP100EU Manual De Instrucciones página 17

Parts:
1.
Air Output Vents
2.
Control Panel
3. Front Display
4. Air Purifier Base
5. Air Intake Vents
6. Filter
7. Filter Door
1
1. Remove the filter door located on the
bottom of the air purifier.
4
8 cm
minimum
4. Set up the unit on a level floor surface,
at least 8 cm away from walls and
objects.
SETTING UP YOUR UNIT
1
2
3
2
2. Take the filter out of the unit and remove
packaging, then insert back into the unit.
DO NOT run the air purifier unless
the filter is removed from its packaging
and properly reinstalled.
5
5. Plug the unit into an electrical outlet
and press the power button on the top
control panel.
4
5
6
7
Remove filter
from plastic
packaging
TIPS FOR SETTING UP YOUR UNIT
• Make sure the front panel of the unit faces away
from the closest wall.
• Do not move the unit while it is running. Turn
off the power and unplug the unit before
moving it.
• Make sure the vents are not blocked.
• Do not place anything on the air purifier.
• Do not place the air purifier near heaters or
radiators.
• Keep the unit out of direct sunlight and away
from water or other liquid.
• Keep all nearby doors and windows closed
when operating the air purifier.
• Avoid using in very humid environments.
3
3. With the filter installed, replace the filter
door. Twist the filter door until clicks into
place.
6
6. When the unit is powered on, it will begin
to analyse the air quality indicated by the
rotating lights. After a few seconds the
unit will display the current air quality
and you can customise the settings on
your unit.