Adjusting The 1 ½" And 2" Pressure Rollers - Southwire MAXIS Xtreme MXB2000 Instrucciones De Operación

Adjusting the 1 ½" & 2" Pressure Rollers
Note: Pressure rollers are not used with Rigid conduit
must be fully engaged so that they apply the appropriate amount of pres-
sure to the conduit. Because of variations in brands and construction of
conduit, the factory setting for the pressure rollers may need to be adjusted
to provide the right around of pressure on the conduit. If the conduit
high. If the conduit becomes kinked or wrinkled, the pressure may be set
too low.
To adjust the roller pressure, do the following:
1. Use a screwdriver to loosen the set screws.
pressure.Be sure to adjust both bolts the same amount so that the roller
pressure is applied evenly. Measure the length of the exposed bolt and
ensure that the length is the same on both sides.
Standard Squeeze Setting
3. Tighten the set screws.
21
Adjustment bolts are
at the same setting
Adjustment bolts are
at different setting
The arrow on the shoe can be adjusted to compensate for variations in
conduit.
1. Load the conduit into the proper shoe groove.
2. Press BEND momentarily until the shoe rotates enough so that the
bottom of the conduit is fully contacting the bottom of the hook.
Retighten the hex head bolt, as shown.
22