Publicidad
Idiomas disponibles
Idiomas disponibles
3) On very hard woods or problem materials it may be
necessary to make more than one pass at progressive
cutting depths until the desired depth of cut is
achieved. When cutting groove, the recommended
cutting depth should no more than 3mm.
4) When edge cutting, the work piece surface should be
on the left side of the milling cutter in the feed
direction.
2, USING THE PARALLEL GUIDE
The parallel guide is an effective aid to cutting in a
straight line when chamfering yr grooving
1) Discharge the base guide.
2) Assembly the straight guide with extension guide
with screw, washer and nut as Follow.
3)
Loosen the clip knob and tighten it to lock the
extension guide as follow. This will assist in keeping
the guide flush with the side of the work piece.
4)
Loosen the string nut adjusting distance between straight guide and milling cutter until it is
at the desired distance.
5)
Tighten the string nut to hold it in position.
NOTE: If the distance between the side of the work piece
and the cutting position is too wide, or the side of the
work piece is not straight, firmly clamp a straight hoard to
the work piece and use it as a guide against the tri, er
base.
10|English
Publicidad
