Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE: The finished cutting sire gets different from the template guide sixe as there is a
distance L from milling cutter to outer edge of template guide，
Equation as below:
TOOL MAINTRINANCE
△WARNING: For your safety, turn off switch and unplug the trimmer from the power source
before performing any cleaning or maintenance. Periodic maintenance allows for long life and
trouble-free operation. A cleaning, lubrication and maintenance schedule should he maintained
1) Replace the milling cutter if damaged nr worn-out:
2) Inspect tool cords periodically and, if damaged, have repaired at your nearest
Authorized Service Center.
3) Keep the trimmer free from oil and grease and store in dry place. Clean all parts of
the trimmer, clean dust and debris from vents. Keep the body clean, dry and free of
oil or grease.
4)
Inspect and change the brush periodically to
ensure safety operation and long use
life. Firstly, screw the brush cap by a
screwdriver. Change the worn brush only change
with Devon's brush, And then tighten the brush
cap.
TROUBLE SHOOTING
△WARNING: For you safety, turn "ONIOFF" switch OFF and unplug drill from the power
source before performing troubleshooting procedures.
1. MOTOR STOPS TURNING
1) Verify plugs fully connect
2) Check power source voltage
3) Check the switch
4) Return the tool for repair when problem remain unsolved after the above checks.
2.
COMMUTATOR SPARKLE
1) Armature short circle
2) If the brush is worn-nut, please replace it with a new one
3) Cnmmutator surface not smooth
ENVIRNMENT ROTECTION
I. Tool, accessories and packaging should be sorted for environment friendly recycling.
2.
Some dust created by working contains harmful chemicals must be collected by special
garbage recycle site.
13|English
Publicidad
