Safety Notes; Conformity And Approval; Rack Mounting - Monacor TXA-802SR Manual De Instrucciones

2-Channel Receiver
for Audio Transmission System
These instructions are intended for users without
any specific technical knowledge . Please read these
instructions carefully prior to operation and keep
them for later reference .
All operating elements and connections de-
scribed can be found on page 2 .
1 Overview
1 POWER switch for the receiver
2 Controls, one each for receiver unit A and receiver
unit B: to switch the respective receiver unit on /
off and to adjust the volume
3 Display: indicates the transmission channel and
the strength of the radio signal received
(left: receiver unit A; right: receiver unit B)
4 Buttons SET,  and  to make settings; see chap-
ters 6 .1 .1 to 6 .1 .3
5 Receiving antennas
6 XLR audio output for connection to a balanced
microphone input
7 Audio output via 6 .3 mm jack (unbalanced) for
connection to a line input; use the switch next to
this output to select the output level, depending
on the sensitivity of the line input
8 Switch to select the output level of the 6 .3 mm
jack (see above)
9 Low-voltage jack to connect the power supply
unit provided

2 Safety Notes

The units (receiver and power supply unit) corre-
spond to all relevant directives of the EU and are
therefore marked with
WARNING
The power supply unit uses danger-
ous mains voltage . Leave servicing
to skilled personnel only . Inexpert
handling may result in electric shock .
•
The units are suitable for indoor use only . Protect
them against dripping water, splash water and
high air humidity . The admissible ambient tem-
perature range is 0 – 40 °C .
•
Immediately disconnect the power supply unit
from the mains
1 . if the receiver or the power supply unit is visibly
damaged,
.
2 . if a defect might have occurred after the unit
was dropped or suffered a similar accident,
3 . if malfunctions occur .
In any case the unit must be repaired by skilled
personnel .
•
For cleaning only use a dry soft cloth; never use
water or chemicals .
•
No guarantee claims for the units and no liabil-
ity for any resulting personal damage or material
damage will be accepted if the units are used for
other purposes than originally intended, if they are
not correctly connected or operated, or if they are
not repaired in an expert way .
If the units are to be put out of operation
definitively, take them to a local recycling
plant for a disposal which is not harmful
to the environment
3 Applications
The multifrequency receiver TXA-802SR works
with 2 × 16 channels in the UHF frequency range
863 – 865 MHz . With two matching transmitters
(e . g . TXA-800HSE, TXA-800HT, ATS-12HT), two
wireless audio transmission paths can be established .

3.1 Conformity and approval

Herewith, MONACOR INTERNATIONAL declare that
the receiver TXA-802SR complies with the directive
2014 / 53 / EU . The EU declaration of conformity is
available on the Internet:
www .monacor .com
The receiver is generally approved for operation in
EU and EFTA countries; it is licence-free and re-
quires no registration .

4 Rack Mounting

With the mounting material supplied, two receivers
TXA-802SR can be inserted into a rack for units with
a width of 482 mm (19") . In the rack, 1 RS (rack
space = 44 .5 mm) is required .
Use two connection plates (one on the upper
side, one on the lower side) to screw the two re-
ceivers together . Screw a mounting bracket onto
the left and right sides of the pair of receivers; then
insert the pair of receivers into the rack by means
of the mounting brackets .
7