Wiring Diagram - NORAUTO DX DR-211BT Manual

After Bluetooth connection is completed, when there is a call in, it can be
answered by short pressing the " " key on the panel. In order to switch the voice,
the " " key on the panel can be long pressed to switch the call between the mobile
phone and the host. After the call is over, the call can be hung up after pressing
the " " key on the panel.
4. Playing music via Bluetooth
After Bluetooth connection is completed, BT mode can be switched after pressing
the "MODE" key, the music in the phone can be played after pressing the "
on the panel at this time, the play can be paused after pressing it again, and the
music can be selected after selecting keys " and ".

WIRING DIAGRAM

10A fuse
Connect to
the car key
Rear left
loudspeaker
Front left
loudspeaker
SCHEMATIC DIAGRAM OF INSTALLATION AND DISASSEMBLY
1. Schematic diagram of installation
• The host will be placed as per the installation position before installing the host,
which shall be connected to the corresponding horn wire and power Stator line.
• The host can be fixed after the host running effect is satisfactory.
2. Install the host
• Install the bracket on the instrument panel of the vehicle and bend the part of
Red
Green
Green black
White
White black
Black gray
Black
Connect to battery cathode
Yellow
Connect to battery anode
Blue
Connect to automatic antenna
Purple
Rear right loudspeaker
Purple black
Gray
Front right loudspeaker
" key
Front left audio
output 1 (white)
Front left audio
output 2 (white)
Front right audio
output 2 (red)
Front right audio
output 1 (red)
51
EN