Salicru EQUINOX EQX2 2001-S Manual De Usuario página 50

The connection terminals are located at the bottom of the unit,
as shown in the following table:
Item Terminal

DC switch

DC input terminal

COM1 port

COM2 port

AC output terminal
Tab. 4. Connection terminals.
5.3. SCREEN INTERFACE
AND WIFI MODULE.

Fig. 10. Synoptic chart view.

Fig. 11. Wi-Fi module view.
50
Note
On/Off switch
PV Connector
WiFi connector
CT/RS485 connector
Connection for AC output



Indicator Item Status
No voltage detection or input
Off
voltage too low.
Slow Inverter On, waiting for grid
flash connection.
On

indicator
Fast flash Grid detected. Self-test mode.
Normal, connected to the grid
On
and generating energy.
Displays inverter operation
On
information.
OLED

If there is no response when
display
Off pressing the button, the screen is
faulty or not connected properly.
Change the information on
the OLED screen and set the

Button (Physical)
parameters with a short press
and long press.
 The communication between
the inverter and the server is
On
normal. However, the inverter

reports an error.
The WiFi module is not properly
connected to the inverter's

"Com" port. The WiFi module is
restored.
Off
Changed router or password.

The WiFi signal is too weak at
the place of installation.
Alarm
indicator
Slow

flash The WiFi module is not
connected to the router.

Off

Fast flash
The WiFi module connects to the
router, but not to the server

On

Off
Communication between
inverter and server is normal.

On
Tab. 5. Synoptic chart elements and WiFi module.
Description
Check the guide for more information
about common faults and
troubleshooting.
Check if the WiFi module is connected
properly to the inverter. Remove and
insert the Smart Dongle; Restart the
inverter.
Remove and insert the Smart Dongle;
configure the WiFi module, move the
router closer to the inverter. Register
the user account in the application.
1. Remove and insert the WiFi
module.
2. Reload WIFi3. Configure the WiFi
module again.
Check that the router has an Internet
connection.
Check that the firewall is not blocking
port 5743.
Communication is normal.
Solution
SALICRU