Rollei HS Freeze 4s Manual De Instrucciones página 32

Operation
32
Easy Cap Mode
The Easy Cap Mode can be used to easily cut out the main subject from the
background with the help of an image processing software (available seperately).
A minimum of two flash units are required for this operation.
1. Activate the Easy Cap mode on your flash.
2. Set the number of groups that are needed. Therefore press the corresponding
function button and rotate the dial to change the value. The maximum setting of
the groups is limited to 6 (All6), but within each group the quantity of flashes
is unlimited.
3. Then set the sequence of the groups. Therefore press the corresponding function
button and change the value by rotating the wheel Here you set the sequence of
when the flash will be released. After the setting the groups will flash according
to this sequence.
Example (working with 4 flashes)
1. There are 2 groups related with Easy Cap mode, therefore the group setting
is set to „All2".
2. There are two flashes which will be the main flashes and they are set to „No1"
(group 1). Then they will be triggered with the first frame (see figure 1 –
correctly exposed picture).
3. The two background flashes are set to „No2" (group 2. and they will not be
triggered in the first frame but in the second one (see figure 2 – no exposure on
main subject, only the background).
4. With the help of image processing software, the main subject can now be quickly
cut out from the background.
1
ENGLISH
2