Rollei HS Freeze 4s Manual De Instrucciones página 41

Warnings and Safety Instructions
– Note that the flash tube, modelling light and a connected reflector can become
very hot during operation. Do not touch these parts during or immediately after
operation. Allow the unit components to cool down before replacing the flash
tube or reflector.
– Handle glass parts such as the flash tube with care so that the glass is not
broken. Do not touch the flash tube with bare hands, use clean cotton gloves or a
microfibre cloth. Small residues of skin grease can cause the flash tube to burst.
– Make sure that the flash tilt lever is firmly tightened before using the unit and
connecting accessories to it.
– Mount the flash unit on a tripod with sufficient load-bearing capacity and set up
the tripod so that it cannot tip over or slip.
– For storage or transport, disconnect the battery from the flash unit.
– Allow the flash to cool down before packing it for transport or storage.
Warnings for rechargeable batteries
– Do not dismantle, hit or puncture the battery, take care not to short-circuit the
battery.
– Do not expose the battery to high temperatures.
– Do not continue to use the battery if it leaks or expands.
– Always charge through the system. If the battery is replaced with the wrong type,
there is a risk of explosion.
– Keep the battery away from children and animals.
– Batteries can explode if exposed to an open fire. Never throw batteries into a fire.
– Dispose of used batteries according to local regulations.
– Before disposing of the unit, remove the battery and dispose of it separately.
– Batteries must be fully charged before using the unit for the first time.
41