Publicidad
Idiomas disponibles
Idiomas disponibles
2.
When the fan is turned on or off, press and hold the
for five seconds. All the LED indicators on the control panel light up and flash.
3.
Then press any button on the remote control. The pairing between the fan and the
remote control is activated.
4.
When the pairing/matching completes, the buzzer sounds once, and the LED
indicator on the control panel returns to normal indication before pairing/matching.
5.2 Turn on/off
•
Connect the mains plug of the power cable (9) to the mains (220 - 240 V/AC, 50 Hz).
•
To turn the fan on or off, tap the
control).
5.3 Set speed
•
When the fan is on, tap the
remote control) to select a speed level (totally 3 speed levels). The corresponding
speed level indicator is displayed on the control panel (13).
5.4 Set oscillation
•
When the fan is on, tap the
control) to activate or deactivate oscillation.
5.5 Set timer
You can set a time at which the fan will automatically turn off.
•
When the fan is on, tap the
control) to set a timer (up to 8 hours can be set). The set time is displayed on the
control panel (13).
5.6 Fan head adjustment
Turn the fan head upwards or downwards to adjust angle of
airflow.
5.7 Height adjustment
Install one or both stand tubes (upper and lower stand tubes) to
adjust the fan height (see "Installation > "Assemble main body").
5.8 Replacement of remote control battery
The remote control is powered by a CR2025 button cell. Replace the battery when the
battery depletes.
•
Find the battery compartment door on the back of the remote control. Press and
hold the tab (A) and simultaneously pull the battery tray out (as shown in the figure
below), and place a new CR2025 battery in the battery tray with correct polarity
indicated, then close the battery tray.
icon on the control panel (13) (or on the remote
icon on the control panel (13) (or press / on the
icon on the control panel (13) (or on the remote
icon on the control panel (13) (or on the remote
11 11
button on the control panel (13)
EN
Publicidad
