Descargar Imprimir esta página

Gate Access (Wired) - LiftMaster Smart Video Intercom S Manual De Instalación

Publicidad

Idiomas disponibles

Idiomas disponibles

INTRODUCTION

Gate Access (Wired)

Disconnect power BEFORE making electrical connections. Below is an example of a wiring setup for gate access.
WIEGAND
KEYPAD
NOTE: For KPR2000 keypad
wire the pink and black (ground)
wires together.
SUPERVISED
(GATE STATUS)
(Not applicable for wireless
gate operator connections)
GATE OPERATOR
EXTERNAL FREE EXIT
(connect to Aux Closed Limit
switch - refer to gate operator
manual)
EOL (End of Line)
Resistor
(1k ohm)
PRIMARY RELAY
GATE OPERATOR
*AUXILIARY RELAY
MAGLOCK
Use 18-22 AWG
For DC Power:
Install a 1N4005
diode or equivalent
ACCOUNT SETUP
OR
REQUEST TO EXIT
PUSH
LOOP DETECTOR
BUTTON
OR
EXIT
COMMON
For AC Power:
Install a Siemens S10K30MOV
(Metal Oxide Varistor) or
equivalent
NORMALLY CLOSED
COMMON
+
Power for Maglock
(Not Provided)
DO NOT use the power
supply for the controller
POWER
NETWORK/MOUNTING
12 VDC POWER SUPPLY
READER
POSTAL LOCK**
POSTAL LOCK
NORMALLY OPEN
COMMON
GROUND
REQUEST TO EXIT
NORMALLY OPEN
NORMALLY OPEN
NORMALLY CLOSED
AUXILIARY RELAY
Low
Voltage
Power
Supply
Isolation
Relay
NOTE: DO NOT
connect high
voltage power to
the CAPXS unit.
ALARM BYPASS
COMMON
NORMALLY OPEN
16
ACCESS CONTROL
POWER
DATA 0
DATA 1
GROUND
SUP
COMMON
COMMON
ETHERNET CONNECTION
LIGHT
DO NOT INSTALL THE
SYSTEM IN THE FAIL
LOAD
SECURE MODE UNLESS
LINE
PERMITTED BY THE LOCAL
AUTHORITY HAVING
JURISDICTION. Doing so may
OR
cause interference with the
operation of panic hardware.
* NOTE: MAGLOCK and ALARM BYPASS
not evaluated by UL.
** NOTE: For more information on how
to wire in a postal lock, refer to the
manual for accessory: CAPXSTKPL.

Publicidad

loading

Este manual también es adecuado para:

Capxs