Repairing A Puncture In The Air Pole - Dometic Ace AIR Pro Instrucciones De Uso

Problem Solution
➤ Check that all isolation valves that
Part of the
connect the air poles are open.
awning tent
does not
deflate
➤ Add more air (9 psi/0.62 bar).
Air poles are
kinked
➤ Check that the valve is fully
Air leak
screwed into the air pole and the
ring seal is in place.
➤ Check that the cap of the valve is
done up tightly.
➤ Check for punctures, see chapter
"Repairing a puncture in the air
pole" on page 14.
➤ Check for leaky seams, damaged
Water leak
tapings and moist areas.
➤ If you cannot find any leaks, see
chapter "Condensation" on
page 14.
➤ If you find any leaks, apply seam
sealant.
➤ Use repair tape to seal the fabric.
Rip in the fab-
➤ Have repairs carried out by an
ric
authorized specialist.
Condensation
All awning tents suffer from internal condensation if
one or more of the following conditions apply:
• High air humidity
• High ground moisture
• A drop in temperature
Severe condensation can run down the inside of
the roof and drip off ties, tapes and other internal
fittings and can be mistaken for leaking.
➤Increase ventilation by opening doors and/or
windows.
➤Install a waterproof groundsheet.

Repairing a puncture in the air pole

If the air pole loses air, proceed as follows:
1. Unzip the outer sleeve holding the air pole.
2. If installed, close isolation valves.
3. Remove the air pole.
14
4. Deflate the air pole.
5. Unzip the protective sleeve to expose the
inflatable tube.
6. Blow some air into the inflatable tube.
7. Submerge the tube in water.
8. Locate the puncture.
9. Use repair tape and repair solution to seal the
hole.
10. Zip the inflatable tube back into the protective
sleeve.
11. Zip the air pole back into the outer sleeve.
Disposal
➤ Place the packaging material in the appro-
➤ Consult a local recycling center or special-
Warranty
The statutory warranty period applies. If the prod-
uct is defective, please contact your retailer or the
manufacturer's branch in your country (see
dometic.com/dealer).
For repair and warranty processing, please include
the following documents when you send in the
product:
• A copy of the receipt with purchasing date
• A reason for the claim or description of the fault
Note that self-repair or non-professional repair can
have safety consequences and might void the war-
ranty.
The warranty covers manufacturing defects, mate-
rials and parts. The warranty does not cover fading
of the cover and wear and tear due to UV radiation,
misuse, accidental damage, storm damage, or
permanent, semi-permanent* or commercial use.
It does not cover any resulting damage. Please
contact your dealer for claims. This does not affect
your statutory rights.
4445103255
priate recycling waste bins wherever pos-
sible.
ist dealer for details about how to dispose
of the product in accordance with the
applicable disposal regulations.