Transportation And Storage; Store The Machine; Troubleshooting - Cramer A48T10BC-CR Manual

EN
• Keep the air vents clean and free of debris to avoid
overheating and damage to the motor or the battery.
• Do not spray water onto the motor and electrical
components.
6 TRANSPORTATION AND
STORAGE
Remove the battery pack from the machine before

transportation and storage.

6.1

STORE THE MACHINE

• Remove the battery pack from the machine.
• Make sure that children cannot come near the machine.
• Keep the machine away from corrosive agents such as
garden chemicals and de-icing salts.
• Secure the machine during transportion to prevent
damage or injury. Clean and examine the machine for any
damage.
7

TROUBLESHOOTING

Problem Possible Cause
The ma- The guard is not
chine stops attached to the ma-
when you chine.
cut.
Cutting blade is
damaged.
The grass winds
around the motor
shaft or the trim-
mer head.
The motor is over-
loaded.
WARNING
Solution
Remove the battery pack
and attach the guard to
the machine.
Replace the blade (al-
ways wear protective
gloves).
1. Stop the machine.
2. Remove the battery
pack.
3. Remove the grass from
the motor shaft and trim-
mer head.
1. Remove the trimmer
head from the grass.
2. The motor will recover
to work as soon as the
load is removed.
3. When you cut, move
the trimmer head in and
out of the grass to be cut
and remove no more than
8" in pass.
English
Problem Possible Cause
Nut cannot Damaged thread
be removed on nut/ shaft.
to release
cutting
blade.
Cutting Cutting blade ob-
blade fails structed
to rotate.
Blade nut loose
Grass too high/
dense
The grass Cut tall grass at
winds ground level.
around the
trimmer
head and
motor hous-
ing.
Vibration Cutting blade
increases damaged.
obviously.
Debris build up on
cutting head
Blade nut loose
Cutting blade in-
correctly fitted
Poor cut- Cutting guard en-
ting per- crusted with debris
formance
Cutting blade
blunt
6
Solution
1. Cut with the tip of the
line, avoid stones, walls
and other hard objects.
2. Advance the cutting
line regularly to keep full
cutting width.
Check underneath the
machine and clear out as
necessary (always wear
protective gloves).
Tighten nut ensuring the
blade, rider plate and
dome washer are all
present and central (al-
ways wear protective
gloves).
Grass too high: Cut in
stages
Grass too dense: Reduce
rate of cutting every time.
1. Cut tall grass from the
top down.
2. Remove no more than
8" in each pass to prevent
wrapping.
Replace the blade (al-
ways wear protective
gloves)
Clean cutting head and
remove debris
Tighten nut bolt to ensure
the blade, outer cup and
plate are all present and
central (always wear pro-
tective gloves).
Remove cutting blade
and refit in a fully central
position. Use guide rings
on the blade to ensure
correct central alignment.
Clean inside of cutting
guard
Flip/replace blade