Descargar Imprimir esta página

MTX Audio X3000D Manual De Instrucciones página 2

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 10
X3000D
All manuals and user guides at all-guides.com
- amplifier owner's manual
Introduction
Thank you for choosing an MTX X THUNDER Amplifier to power your car audio system. Each MTX X THUNDER
amplifier is CEA2006 certified which means you have a 100% guarantee that your amplifier will deliver every Watt
it is rated at.
Specifications
Ratings:
• CEA2006 certified Power Output: 2000 Watts RMS at 2 ohm and ≤ 1% THD+N
• CEA2006 certified Power Output: 3000 Watts RMS at 1 ohm and ≤ 1% THD+N
• Two amps strapped Power Output: 4000 Watts RMS at 4 Ohm
• Two amps strapped Power Output: 6000 Watts RMS at 2 Ohm
• Signal-to-Noise Ratio (1 watt) : >75dB
• THD+Noise (Distortion) (1 watt) : ≤1%
• Frequency Response (-1dB) : 20Hz-250Hz
• Maximum Input Signal : 5V
• Maximum Sensitivity : 250mV
• Minimum impedance : 1 Ohm
• Dimensions : 580mm x 210mm x 50mm
• Crossover : Low pass 24dB variable from 40Hz to 200Hz
• Subsonic filter : High pass variable from 20Hz to 50Hz
• Phase switch : 0° or 180°
• Master/Slave function
• High level input connection
Input/output panel layout
1. RCA input jacks – These RCA input jacks are for use with source units that have RCA or Line level outputs. A
source unit with a minimum level of 250mV is required for proper operation. The use of high quality twisted pair
cables is recommended to decrease the possibility of radiated noise entering the system.
2. RCA Master out - Master out connection when two MTX X3000D amps are used in a "strapped" configuration
(see paragraph strapping two X3000D amps).
3. RCA Slave in - Slave in connection when two MTX X3000D amps are used in a "strapped" connection (see para-
graph strapping two MTX X3000D amps).
4. Speaker level inputs – This input will allow the amplifier to operate from source units with speaker-level outputs.
Output speaker leads from the source unit should be tied directly to the wire harness provided with the amplifier.
**Note: When speaker level inputs are used it is still needed to connect a remote wire to switch the amplifier on
and off.**
2

Publicidad

loading