Russell Hobbs Attentiv 26200-70 Manual página 5

Hibiscus
Pu-erh
Mate
Herbal/Fruit
Coffee
Instant coffee
Filter ground coffee
For baby milk/formula, follow the manufacturer's instructions, or local health authority guidance.
USING THE INFUSER AND STEEP TIMER
The steep timer allows you to time infusions when using the infuser accessory. You must first heat the
water to the desired temperature see HEATING WATER TO A SELECTED TEMPERATURE. The timer can be
set from 1 to 40 minutes.
Note: When using the infuser, only fill your kettle to the 1.5L marking. This will allow room for the infuser
and its contents when you insert it into the kettle, and prevent water from being displaced out of the
spout.
1. Prepare the infuser accessory by putting the desired amount of tea leaves into it.
2. When the water reaches the desired temperature, open the lid and put the infuser into your kettle.
The notch in the infuser should face the handle.
3. Tap the N icon.
4. Turn the select/confirm knob until the desired steeping time is shown on the numerical display.
Turning the control slowly will increase/decrease the time in 1 minute intervals. Turning the control
quickly will increase/decrease the time in 5 minute intervals.
5. Press the select/confirm knob G. The last used temperature will then be displayed.
6. Turn the select/confirm knob to adjust desired temperature (or skip this step if the current
temperature is already correct).
7. Press the select/confirm knob G to start the countdown.
8. Your kettle will beep when the time is up. Note that the infusion will start to cool down naturally
after the timer has elapsed.
9. To cancel at any time you can tap the cancel Bicon.
KEEP WARM MODE
This mode allows you to keep the heated water at a specified temperature. The keep warm mode can be
set from 1 to 40 minutes.
1. Tap the N icon.
2. Turn the select/confirm knob until the desired keep warm time is shown on the numerical display.
Turning the control slowly will increase/decrease the time in 1 minute intervals. Turning the control
quickly will increase/decrease the time in 5 minute intervals.
3. Press the select/confirm knob G. The last used temperature will then be displayed.
4. Turn the select/confirm knob to adjust desired temperature (or skip this step if the current
temperature is already correct).
5. Press the select/confirm knob G to start the countdown.
6. Your kettle will beep when the time is up.
7. To cancel at any time you can tap the cancel Bicon.
70 – 75
80 – 100
90 – 100
90 – 100
Temperature °C
85 - 95
80 - 90
5
5 - 7
2 - 5
5 - 6
3 - 5
Brewing time (min)
-
-
GB
DE
FR
NL
IT
ES
PT
DK
SE
NO
FI
RU
CZ
SK
PL
HR
SI
GR
HU
TR
RO
BG
UA
AE