Di4 Acqua Rs3 Instrucciones Originales página 53

The machine stops
Pulsation of the machine
The machine starts and stops
automatically
The machine starts, but the
water does not come out
The water supply is not enough
Worn out pump seals
The fuse is blown
Mains voltage incorrect
Thermal sensor activated
Jet is partially blocked
Air in the inlet hose / pump
Inadequate supply
Jet is partially blocked
Blocked water filter
Hose bending
Leaky shotgun and/or trigger
No water supply
Blocked water filter
Blocked jet
Increase the water pressure,
check for blockage of the hose
and / or change the large hose.
Contact your service center
Contact your service center
Disconnect the other machines.
Check that the mains voltage
corresponds to the
specification on the nameplate
Let the machine cool down for 5
minutes
Clean the jet with a needle and
spray some water toward the rear
through the jet
Let the machine operate with
the open trigger until the working
pressure resumes regularly.
Increase the water pressure,
check for blockage of the hose or
change the large hose
Clean the jet with a needle and
spray some water toward the rear
through the jet
Clean the filter
Straighten the hose.
Contact your nearest service
center
Connect the water inlet.
Clean the filter
Clean the jet with a needle and
spray some water toward the rear
through the jet
53