Publicidad
Idiomas disponibles
Idiomas disponibles
WATER TANK CLEANING
- Unplug the appliance and then remove the screws that secure the rear filter frame.
- Lift the filter frames to remove them from the unit.
- Drain the tank by removing the plug at the bottom rear of the tank.
- With a cloth (moistened with a neutral detergent), clean the water tank and rinse it with water.
- We recommend emptying the tank and refilling it with fresh water if the water has been in the
tank for a period length of time.
MAINTENANCE AND CHANGE OF HONEYCOMB FILTER PADS
The appliance is supplied with a set of honeycomb cooling pads/filters. Filter cleaning frequency
depends on local air and water conditions. In areas where the mineral content of the water is high
(hard water), mineral deposits can build up on the filter and restrict airflow. If mineral deposits
remain on the pads, the filter should be removed and washed with water. We recommend
cleaning the Honeycomb filter at least every two months, depending on your needs.
For best results, allow the filter to dry after each use by turning off the cool down function for 15
minutes (with an empty water tank) before turning the unit off.
Unplug the power cord, then unscrew the screws that hold the
filter frames in position. Remove the filter frames from the appliance and remove the filter from
the frame. With a neutral detergent and a soft brush, rub the filter, clean with water and dry.
Do not submerge in water.
END OF SEASON MAINTENANCE
- Empty the tank and clean it with warm soapy water.
- Dry the tank and clean the Honeycomb pads.
- Store any ice packs you may use in the water tank
- Cover the unit and keep it in a dry place.
VERY IMPORTANT NOTE
Before storing the appliance until the following summer season or use,
clean the water tank and all the filters well.
Once the filters are clean, let them dry completely.
Do not store the device with wet filters as they can breed harmful particles
to health by not perspiring well and an annoying musty smell.
Publicidad
