Publicidad
Idiomas disponibles
Idiomas disponibles
6. Super FRZ. mode
Press key C to select Super FRZ. mode, the icon 6 turns on. U pon the lock, the
refrigerator will run under the Super FRZ . mode.
Super FRZ. is automatically disabled after 25h.
7 . Refrigerator compartment temperature settings
Press the key REF.TEMP. (Key A), the refrigerating temperature area gives a
prompt by flashing. Then, press the key REF.TEMP. to adjust the setting
temperature upon the beep. The temperature changes 1ºC each press, ranging
between 2~8ºC.
The temperature adjustment sequence is:
8ºC > 7°C > 6ºC > 5ºC > 4ºC > 3ºC > 2ºC > 8ºC > 7°C···
Upon the temperature adjustment, the display flashes for 5s and the new
setting temperature is effective upon the lock.
8. Freezer room temperature settings
Press the key FRZ .TEMP. (Key B), the freezing temperature area gives a prompt
by flashing. Then, press the key FRZ.TEMP. to adjust the setting temperature
upon the beep. The temperature changes 1ºC each press, ranging between
-16~-24ºC.
The temperature adjustment sequence is:
-16ºC > -17° > -18ºC > -19ºC > -20ºC > -21ºC > -22ºC > -23ºC > -24ºC > -16ºC > -17°C···
Upon the temperature adjustment, the display flashes for 5s and the new
setting temperature is effective upon the lock.
Recommended setting: Refrigerated chamber 4ºC, freezing chamber -18 ºC.
Note: when the set temperature of freezer changes, if a relevant function mode
has been previously set (e.g. quick-cool mode, quick-freezer mode, quick-cool
and freezer mode, vacation mode), the relevant function mode shall be quitted
or canceled at once.
Warnings
The refrigerator uses alternating current supply, which is 220-240V/50Hz. If the
voltage fluctuations are large (over the scope of 198-264V), it may cause some
failures, such as the refrigerator not starting, the main control board and
compressor burn and the compressor works with abnormal noise, etc. If this is
the case, you must install an automatic voltage regulator above 1000w for use.
The refrigerator's power cord with a three-plug (grounding) complies with the
standard three-socket (grounding). Don't cut off or remove the third pin of the
power card under any circumstances. After the refrigerator is installed, plugs
should be easily reached to facilitate use. The power plug must have firm
contact with the socket, otherwise it might cause fire.
Do not grasp and drag the power cord to pull out the refrigerator plugs. Hold
the plug firmly, and pull out the plug from the socket directly. Make sure the
power lines are not pinned by the refrigerator or trampled by people. Be careful
when the refrigerator is separated from walls so as not to roll or damage power
lines. Do not use power lines and plugs that are damaged or worn out. If they
are, please contact the authorized service center closest to you so they change
them.
14
V.1
Publicidad
