Important - Beninca ONE.2WB-MS Manual De Instrucciones

433,92MHz Radioreceiver 2 channels, multiple decoding, compatible
with Advantouch system.
The standard memory can contain 512 rolling-code, 433.92MHz, transmitters
maximum An expansion memory is available with the possibility of containing
2048 codes (Art. 9570001- MEM 2048). A full memory is indicated by 10
orange blinks.
N.B: The Advantouch palm programmer and related management software
permit the use of certain advanced functions, please consult the relevant
instruction manual for more information.
The radio receiver ONE.2 is compatible with the new ARC (Advanced Rolling
Code) transmitters which, thanks to 128-bit encryption ensure superior copy-
security.
Storing new ARC transmitters is quite similar to that of normal rolling code
transmitters with HCS coding, but be aware that:
1) ARC transmitters and Rolling Code HCS can not be stored in a single
receiver.
2) The first transmitter memorized determines the type of transmitters to be used
later.
3) If you want to change the type of transmitters it is necessary to proceed
with a receiver reset (as described in the manual).
To optimise reception install the antenna away from metal bodies and
avoid positioning several receivers next to each other. If no antenna is used
reception will be considerably reduced.
Memorising transmitters – Simplified procedure
To merely record one or more transmitters to activate the first channel, follow
this simplified procedure:
1 Press and release the button P on the receiver.
2 The Red LED will light up for 3 secs, then go out for 1 sec and then light
8
ENGLISH

IMPORTANT:

up again for 5 secs.
3 While the red LED is on, press the button on the transmitter to associate
with channel 1.
4 Other transmitters can be then be recorded by pressing a button within 5
secs from recording the previous transmitter.
5 To end wait 5 secs, the receiver will exit programming.
Memorising a transmitter – Remote self-learning
If a transmitter has already been memorised on the receiver the remote radio
self-learning feature can be used (without having to use the receiver button
P). Proceed as follows:
1 Press the hidden button on the memorised transmitter.
2 Press, within 5 secs., the button on the memorised transmitter
corresponding to the channel to associate with the new transmitter.
3 Press, within 5 secs., the button on the new transmitter to associate with
the channel selected at point 2 above.
4 The receiver will memorise the new transmitter and promptly exit
programming.
Transmitters can be memorised and separate channel modes can be set
using the button "P" (see Fig.1/2).
To go from one programming mode to the next press the button P within 3
secs from one press and another.
Once having selected a programming mode, wait for about 3-4 secs and
a LED signal with indicate that programming has been entered (see
"Operations" column).
Table 1 lists the various programming modes.
* After pressing the button on the first transmitter the receiver will wait 5 secs
to memorise another transmitter.
In this way all the transmitters being associated with one channel can be
recorded in sequence. After the 5 secs the receivers exits the programming
mode. When using this method of recording in sequence it is best to
Programming